(1) The installation height of the wall lamp must slightly exceed the height of the line of sight by about 1.8 meters. The illumination of the wall lamp cannot be too high. Mainly focused on auxiliary lighting and decoration effects.

(2) Firstly, the indoor height is determined, and the installation height of the wall lamp is approximately 1.8 meters above the line of sight. The height of the wall from the light to the working surface is 1440-1850, and the height from the ground to the ground is 2240-2650.

(3) The distance from the bedroom wall lamp to the ground can be very close, about 1400-1700 millimeters. The wall distance of the wall lamp is also very close, between 95-400 millimeters, and the specific size and actual situation were compared.

Details of wall lamp installation

(1) Mark the positions where expansion screws need to be nailed on the wall according to the holes on the wall light panel, and accurately measure the data in combination with the installation drawings to avoid errors.

(2) Use an electric drill to drill holes in the marked areas on the wall, understand the layout of the circuit in advance, do not drill into the electrical wires, and grasp the depth of the drilling.

(3) After opening the hole, start tightening the expansion screw. Firstly, push the expansion screw into the already opened hole, and then use a hammer or something to drive the expansion screw into the wall until it disappears completely.

(4) Thread the wooden screw through the hole used for hanging the wall lamp and tighten it onto the expansion screw. The fixation on both sides is carried out alternately to play a stable role and prevent the wooden screws from being misaligned.

(5) Connect the hanging plate and suction cup with screws, tighten the head screws, and firmly fix the suction cup. Finally, cut off the indoor power supply, connect the wires and power lines of the wall lamp, and finally install the wall lamp.

(6) The installation method of wall lamps is relatively simple. Generally, after the position is determined, the wall lamp socket is prepared for fixation, and then embedded materials or drilling methods are used to fix the wall lamp.

(7) The wires connecting the wall lamp are easy to match the color of the wall paint. To maintain the cleanliness of the wall, bright colors can be chosen. Dig a small groove on the wall that can tightly embed the wires, embed the wires, and then bury them flat with lime. Please pay attention to the railway plan. Using a straight line as the center without bending, apply paint of the same color as the wall.