1. In the shortest time, use a centrifugal fan or other special tools to completely dry the water inlet screen.

2. The screen body after being thoroughly dried is energized and aged, and the operation steps are as follows:

①. Adjust the brightness (full white) to 10%, and aging for 8-12 hours after power-on.

②. Adjust the brightness (full white) to 30%, and aging for 12 hours after electrifying.

③. Adjust the brightness (full white) to 60%, and aging for 12-24 hours after power-on.

④. Adjust the brightness (full white) to 80%, and aging for 12-24 hours after power on.

⑤ Adjust the brightness (full white) to 100%, and aging for 8-12 hours after power-on.

3. When the above process is carried out, most of the screen body may be recovered; however, the following aspects must also be paid attention to in the processing method:

①. When you find water in the warehouse or the LED screen, you should deal with it in an emergency without delaying time.

② The staff of the agency carried out blow-drying treatment on the flooded LED large screen body.

③ It is not necessary to put the large LED screen body that has already been flooded into the air box, it is very easy to damage the LED light.

④. When water enters the warehouse, the air box may enter water, and all air boxes should be exposed to the sun to prevent moisture from evaporating into the LED display screen after the shell is installed.

⑤. Improper handling of all flooded LED displays is likely to harm the reliability of the screen more or less. In the emergency treatment mode, the screen body is likely to cause continuous dead lights after the screen is energized.

⑥. All the flooded LED display screens are in the air box. More than three days, most of the screen body has no use value for repair, please handle it carefully.

The above is the emergency treatment method for the problem of LED display water ingress. After completing the above process, remember to contact the company's after-sales service unit immediately.