In the process of installing the LED street light, first insert the LED street light interface into the φ60 light rod to fix the inner hexagon screw. Pay attention to keeping the LED street light balance during the installation process. In this process After fixing the product and horizontal angle, the lock screw is fixed, and the lamps are installed on the street lamp bracket to align the screw hole position to lock the screw hole, and the lamp is adjusted to the angle of the lamp, so that the lighting angle of the lights meets the specification requirements of the lamp. This process needs to be accurate. In addition, the voltage must be guaranteed during the work process within the rated range, which will cause irreplaceable damage when the rated voltage exceeds the rated voltage.

In installing LED street lights, there are the following details that need to pay attention:

1. The installation height, elevation angle, and installation direction of adjacent street lights should be consistent.

2. The LED lamps installation of the longitudinal center line and the vertical center line of the lamp arm should be consistent. The horizontal horizontal line of the lamp should be parallel to the ground.

3. The company with the lamp head and the street light pole must be firm and standardized.

4. There must be no connectors in the lamp arm, lamp plate, and light rods in LED street lamps. The pore or mouth of the threaded pores should be smooth, no burrs, and the insulation sleeve or bandage should be used. The bandage length should not be less than 200mm.

5, various nuts are fastened, should be added with pads and spring pads. After the tightness, the nuts must not be less than two snail distances.