Turn on the top cover of the lamp for the road street lamp, and turn on the lamp with force before the actual buckle. Insert the cable at the rear of the lithium battery solar street lamp into the lamp chamber according to the optical activity of the cable on the wiring base of the lamp, and then clamp it with the cable sheet. According to the angle of the lighting lamps, the road lamps are placed at the appropriate rotating gear position in the support point tube, and the lithium battery solar street lamps are inserted into the guide holes of the machine equipment support frame. Tighten the reduced anchor bolt of the road lamp to firmly connect the road lamp and the lamp.

1. According to the actual lighting fixtures on the installation site, determine the appropriate lighting installation method (column top and side), and adjust the fixed support. Then, according to the distance between the lamp and the switch power point, make a relatively long three core cable.

2. Firmly open all buttons in front of the lamp, open the upper cover of the lamp, guide the cable into the lamp chamber according to the cable at the rear of the lamp, and connect the cable according to the optical rotation marked on the wiring base of the lamp (the live wire is connected to the "L" position, the ground wire is connected to the "N" position, and the ground wire receives the grounding force).

3. Insert the road lamp into the guide hole of the fixed bracket, select the appropriate position of the road lamp rotating gear, place the road lamp into the supporting point tube according to the angle of the lighting lamp as far as possible, tighten the reduced anchor bolt of the road lamp, and firmly connect the road lamp with the lighting lamp.

4 When removing the light bulb, unscrew the socket, pull out the socket, unscrew the old light bulb, remove the new light bulb, and press the appropriate rotation gear (350W light bulb uses the outermost gear, 350W lighting lamp uses the innermost gear, and the middle gear is for adjustment) to enter the lamp chamber and tighten it.

5 Close the top cover of the lamp and lock the ring buckle. The three core cable can be connected to the urban power engineering to maintain the lighting fixtures.

When lithium battery solar street lamps are used for the first time, the position and aspect ratio of the lighting lamps shall be installed and adjusted as much as possible according to the actual lighting lamps of the on-site lighting lamps. When using, the relevant instructions shall be paid attention to, so as to consider the application requirements as early as possible, consider everyone's needs, and ensure their normal operation.