As the solar street lamp is a new product, many people do not know about the solar street lamp and do not know how to install it in the future. Here, as the technicians of the solar street lamp manufacturer, we will discuss the order of the solar street lamp installation: 1. Dig a pit 10 cm wider than the length and width of the embedded parts and 20 cm higher. 2. Pour C20 concrete with a depth of 20 cm into the pit, Place the embedded parts in the excavated pit, lay it flat, and then pour concrete evenly on both sides until it is equal to the ground, while maintaining the level of the embedded parts. The wiring duct shall be fixed at the same time according to the device construction drawings.

3. After the embedded parts are firm, the solar street lamp will be installed

3-1: Fix the solar panel on the top of the street lamp

3-2: Fix the lamp arm at the required position

3-3: Fix the lamp and fix it on the lamp arm

3-4: Tree pole, set up the fixed solar street lamp, and fasten the bolts on the foundation

3-5: bury the battery, bury the battery in the specified position, and connect the positive and negative poles to the ground.

3-6: Connect the controller. Connect the wires on each component with the controller as the center. The time of connection shall be in accordance with the instructions on the controller, and the connection sequence shall also be in accordance with the instructions. The installation process of solar street lamps is roughly like this. With detailed construction demand experience and exploration, an orderly construction process can reduce idling and waste. If there are problems, you can discuss with us further